Having problems with your Bosch axxis washer? Don’t fret just yet. You can solve the problem on your own with just a few washer tricks.

The anatomical structure of Bosch Axxis Washer is just like any other front load washing machine. That should come as a boon because you do not have to worry about hiring someone with special skills in handling sophisticated washers.

Let me clue you up a bit on its features. It has a horizontal drum made from snag-fee stainless steel that prevents the accumulation of dirt and residues. It has also been integrated with horizontal AA xx wash system and a tumble action that cleans your clothes well without the need for too much water and electricity.

The following are some problems experienced by most owners of this washing machine and the troubleshooting tricks you can try if you have also experienced it:

It Does Not Use The Fabric Softener I Put In Its Dispenser

Prior to starting the washing cycle, you can put fabric softener in the fabric softener dispenser and the washing cycle will get it once the finishes the washing cycle. However, some say they have problems about the washing machine not using the fabric softener. It just stays there until the washing cycle finishes.

If this happens to you, it might need just a bit of cleaning. Take the compartment off and give it a little rinse. When you are not using your washer, clean the compartment as well by washing it warm water coupled with a mild detergent. Get a cleaning brush with a long rod to poke the end of it to make sure that nothing is blocking its exit to the washer tub. If something is blocking the holes on its exit, get Q-tips and poke it until you have gotten rid of the accumulated dirt or sediments in it.

My Washer Makes A Lot Of Weird Noises When It Is Draining Plus It Does Not Drain Efficiently

If your axxis washer is not placed on a sturdy platform, it will definitely make vibrating and chugging noises. You might want to buy a pedestal for your washer and place it on an even surface.

The poor draining cycle may be caused by trapped lint or lime sediments in its drainage system. Look at the draining hose or the drainage exit and see if anything is trapped in it. Extract lint or whatever has accumulated in it. Run an empty hot water cycle and add a cup of white vinegar. Let it sit there for a few minutes so it can dissolve the lime sediments. This should already work well once you have completed the vinegar cycle.

My Washer Always Shows Code E-13 Error Message

If this is the error message your washing machine is sending, it may be caused by inadequate water flow. There might be something trapped in the water hose such as sediments or lime deposits. If you are using tap water, this should be a common problem.

You might want to install a water filter for your Bosch Axxis washer faucet so you can prevent this from happening again. Remove any sediments or dirt obstructing the flow of water in the hose. Pull the sensor that is located n the inlet valve and check inside to see if anything is trapped. If you are using corrosive water, just replace the sensor. If it still works just fine, then cleaning it will suffice.

Back from Bosch Axxis Washer to Washing Machine Reviews